Category Archives: gunsmithing

Trigger job part 2

Posted on June 3, 2009 by

I finished up the rest of the trigger installation this evening. I only needed to fit the trigger to the safety, and then I would be finished. This took a bit more time than I had expected as I was … Continue reading →

Posted in Guns, gunsmithing, triggers | Leave a comment

JP Triggers

Posted on June 2, 2009 by

I’m about half way through installing a JP trigger into my AR. I was a little intimidated at the idea of going this route because of the fitting that might be required to make the trigger work. After watching the … Continue reading →

Posted in gunsmithing, tools, triggers | 1 Comment

Poor man’s trigger pull scale

Posted on May 25, 2009 by

Lately I’ve been giving some attention to the triggers on my rifles. I recently picked up a Clark Custom trigger for my Ruger 10/22. The trigger on my 10/22 was not bad, just that it could be a bit better. … Continue reading →

Posted in Guns, gunsmithing, tools, triggers | 2 Comments